DescriptionField
Delay of the interface, in microseconds.DLY
Reliability of the interface as a fraction of 255
(255/255 is 100 percent reliability), calculated as an
exponential average over 5 minutes.
reliability
Transmit and receive load on the interface as a
fraction of 255 (255/255 is completely saturated),
calculated as an exponential average over 5 minutes.
The calculation uses the value from the bandwidth
interface configuration command.
tx load rxload
Encapsulation type assigned to the interface.Encapsulation
Indicates if loopbacks are set.loopback
Indicates if keepalives are set.keepalive
Address Resolution Protocol (ARP) type on the
interface.
ARP type
Number of hours, minutes, and seconds an ARP cache
entry stays in the cache.
ARP Timeout
Number of bundled ports (members) currently active
and part of the port channel group.
No. of active members in this channel
Number of the bundled port and associated Gigabit
Ethernet port channel interface.
Member <no.> Gigabit Ethernet: <no. /no. /no. >
Number of hours, minutes, and seconds since the last
packet was successfully received by an interface and
processed locally on the Device. Useful for knowing
when a dead interface failed. This counter is updated
only when packets are process-switched, not when
packets are fast-switched.
Last input
Number of hours, minutes, and seconds since the last
packet was successfully transmitted by an interface.
This counter is updated only when packets are
process-switched, not when packets are fast-switched.
output
Number of hours, minutes, and seconds since the
interface was last reset because of a transmission that
took too long. When the number of hours in any of
the “last” fields exceeds 24 hours, the number of days
and hours is printed. If that field overflows, asterisks
are printed.
output hang
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
370
Configuring IEEE 802.3ad Link Bundling
Displaying Gigabit EtherChannel Information
To Next Page
Loading...
Need help?
General
