Cisco Catalyst 3560-X User Manual

1-11
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring Cisco IOS Configuration Engine
Configuring Cisco IOS Agents
Step 13
cns id interface num {dns-reverse | ipaddress |
mac-address} [event] [image]
or
cns id {hardware-serial | hostname | string string |
udi} [event] [image]
(Optional) Set the unique EventID or ConfigID used by the
Configuration Engine.
• For interface num, enter the type of interface–for
example, ethernet, group-async, loopback, or
virtual-template. This setting specifies from which
interface the IP or MAC address should be retrieved to
define the unique ID.
• For {dns-reverse | ipaddress | mac-address}, enter
dns-reverse to retrieve the hostname and assign it as
the unique ID, enter ipaddress to use the IP address, or
enter mac-address to use the MAC address as the
unique ID.
• (Optional) Enter event to set the ID to be the event-id
value used to identify the switch.
• (Optional) Enter image to set the ID to be the image-id
value used to identify the switch.
Note If both the event and image keywords are omitted,
the image-id value is used to identify the switch.
• For {hardware-serial | hostname| string string |
udi}, enter hardware-serial to set the switch serial
number as the unique ID, enter hostname (the default)
to select the switch hostname as the unique ID, enter
an arbitrary text string for string string as the unique
ID, or enter udi to set the unique device identifier
(UDI) as the unique ID.
Command Purpose

Cisco Catalyst 3560-X Specifications

General

Enclosure Type	Rack-mountable - 1U
Subtype	Gigabit Ethernet
Ports	48 x 10/100/1000 + 4 x SFP
Flash Memory	64 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Operating System	Cisco IOS
Device Type	Switch
Performance	Switching capacity: 128 Gbps
Jumbo Frame Support	Yes
Routing Protocol	RIP-1, RIP-2, EIGRP
Remote Management Protocol	SNMP 1, RMON 1, RMON 2, RMON 3, RMON 9, Telnet, SNMP 3, HTTP, HTTPS
Features	DHCP support, VLAN support, QoS, IPv6 support, Syslog
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.1p, IEEE 802.3af, IEEE 802.3x, IEEE 802.3ad, IEEE 802.1w, IEEE 802.1x, IEEE 802.1s, IEEE 802.3ah, IEEE 802.1ag, IEEE 802.3at
Stacking	Stackable
Security Features	SSH, RADIUS, TACACS+
Management	CLI
Dimensions (H x W x D)	17.5 in
Operating Temperature	32 to 113 °F (0 to 45 °C)
Humidity	10 - 95% (non-condensing)