Cisco Catalyst 3560-X - Page 1521

Index
IN-41
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
resequencing ACL entries 1-16
reserved addresses in DHCP pools 1-28
resets, in BGP 1-52
resetting a UDLD-shutdown interface 1-6
Resilient Ethernet Protocol
See REP
responder, IP SLAs
described
1-4
enabling 1-7
response time, measuring with IP SLAs 1-4
restricted VLAN
configuring
1-62
described 1-22
using with IEEE 802.1x 1-22
restricting access
overview
1-1
passwords and privilege levels 1-2
RADIUS 1-17
TACACS+ 1-10
retry count, VMPS, changing 1-30
reverse address resolution 1-10
Reverse Address Resolution Protocol
See RARP
RFC
1058, RIP
1-20
1112, IP multicast and IGMP 1-2
1157, SNMPv1 1-2
1163, BGP 1-45
1166, IP addresses 1-7
1253, OSPF 1-27
1267, BGP 1-45
1305, NTP 1-2
1587, NSSAs 1-27
1757, RMON 1-2
1771, BGP 1-45
1901, SNMPv2C 1-2
1902 to 1907, SNMPv2 1-2
2236, IP multicast and IGMP 1-2
2273-2275, SNMPv3 1-2
RFC 5176 Compliance 1-21
RIP
advertisements
1-21
authentication 1-23
configuring 1-22
default configuration 1-21
described 1-21
for IPv6 1-11
hop counts 1-21
split horizon 1-24
summary addresses 1-24
support for 1-16
RMON
default configuration
1-3
displaying status 1-6
enabling alarms and events 1-3
groups supported 1-2
overview 1-1
statistics
collecting group Ethernet
1-5
collecting group history 1-5
support for 1-18
root guard
described
1-10
enabling 1-18
support for 1-9
root switch
MSTP
1-18
STP 1-17
route calculation timers, OSPF 1-35
route dampening, BGP 1-64
routed packets, ACLs on 1-43
routed ports
configuring
1-5
defined 1-4
in switch clusters 1-8
IP addresses on 1-41, 1-5
route-map command 1-102
route maps