Contents
xv
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
EtherChannel Port Groups 13-6
10-Gigabit Ethernet Interfaces 13-7
Power over Ethernet Ports 13-7
Supported Protocols and Standards 13-7
Powered-Device Detection and Initial Power Allocation 13-8
Power Management Modes 13-9
Power Monitoring and Power Policing 13-10
Connecting Interfaces 13-12
Using the Switch USB Ports 13-13
USB Mini-Type B Console Port 13-13
Console Port Change Logs 13-13
Configuring the Console Media Type 13-14
Configuring the USB Inactivity Timeout 13-15
USB Type A Port 13-16
Using Interface Configuration Mode 13-17
Procedures for Configuring Interfaces 13-18
Configuring a Range of Interfaces 13-19
Configuring and Using Interface Range Macros 13-21
Using the Ethernet Management Port 13-22
Understanding the Ethernet Management Port 13-23
Supported Features on the Ethernet Management Port 13-25
Configuring the Ethernet Management Port 13-25
TFTP and the Ethernet Management Port 13-26
Configuring Ethernet Interfaces 13-26
Default Ethernet Interface Configuration 13-27
Configuring Interface Speed and Duplex Mode 13-28
Speed and Duplex Configuration Guidelines 13-28
Setting the Interface Speed and Duplex Parameters 13-29
Configuring IEEE 802.3x Flow Control 13-30
Configuring Auto-MDIX on an Interface 13-31
Configuring a Power Management Mode on a PoE Port 13-32
Budgeting Power for Devices Connected to a PoE Port 13-33
Configuring Power Policing 13-35
Adding a Description for an Interface 13-36
Configuring Layer 3 Interfaces 13-37
Configuring SVI Autostate Exclude 13-39
Configuring the System MTU 13-39
Configuring the Cisco RPS 2300 in a Mixed Stack 13-42
Configuring the Power Supplies 13-44
To Next Page
Loading...
