Cisco Catalyst 3750-X

Contents
xxxvii
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Configuring Unicast Reverse Path Forwarding 42-89
Configuring Protocol-Independent Features 42-89
Configuring Distributed Cisco Express Forwarding 42-89
Configuring the Number of Equal-Cost Routing Paths 42-91
Configuring Static Unicast Routes 42-92
Specifying Default Routes and Networks 42-93
Using Route Maps to Redistribute Routing Information 42-93
Configuring Policy-Based Routing 42-97
PBR Configuration Guidelines 42-98
Enabling PBR 42-99
Filtering Routing Information 42-100
Setting Passive Interfaces 42-101
Controlling Advertising and Processing in Routing Updates 42-101
Filtering Sources of Routing Information 42-102
Managing Authentication Keys 42-103
Monitoring and Maintaining the IP Network 42-104
CHAPTER 43 Configuring IPv6 Unicast Routing 43-1
Understanding IPv6 43-1
IPv6 Addresses 43-2
Supported IPv6 Unicast Routing Features 43-3
128-Bit Wide Unicast Addresses 43-3
DNS for IPv6 43-4
Path MTU Discovery for IPv6 Unicast 43-4
ICMPv6 43-4
Neighbor Discovery 43-4
Default Router Preference 43-4
IPv6 Stateless Autoconfiguration and Duplicate Address Detection 43-5
IPv6 Applications 43-5
Dual IPv4 and IPv6 Protocol Stacks 43-5
DHCP for IPv6 Address Assignment 43-6
Static Routes for IPv6 43-6
RIP for IPv6 43-7
OSPF for IPv6 43-7
EIGRP IPv6 43-7
HSRP for IPv6 43-7
SNMP and Syslog Over IPv6 43-7
HTTP(S) Over IPv6 43-8