Cisco ONS 15454 - Page 29

Contents
xxix
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Side Switch the Active and Standby Cross-Connect Cards 2-271
2.9.4 Physical Card Reseating, Resetting, and Replacement 2-272
Remove and Reinsert (Reseat) the Standby TCC2/TCC2P Card 2-272
Remove and Reinsert (Reseat) Any Card 2-273
Physically Replace a Traffic Card 2-273
Physically Replace an In-Service Cross-Connect Card 2-274
2.9.5 Generic Signal and Circuit Procedures 2-275
Verify the Signal BER Threshold Level 2-275
Delete a Circuit 2-275
Verify or Create Node Section DCC Terminations 2-275
Clear an OC-N Card Facility or Terminal Loopback Circuit 2-276
Clear an OC-N Card Cross-Connect (XC) Loopback Circuit 2-276
Clear a DS3XM-6, DS3XM-12, or DS3E-12 Card Loopback Circuit 2-276
Clear Other Electrical Card or Ethernet Card Loopbacks 2-277
Clear an MXP, TXP, or FC_MR-4 Card Loopback Circuit 2-277
2.9.6 Air Filter and Fan Procedures 2-278
Inspect, Clean, and Replace the Reusable Air Filter 2-278
Remove and Reinsert a Fan-Tray Assembly 2-280
Replace the Fan-Tray Assembly 2-280
2.9.7 Interface Procedures 2-281
Replace the Electrical Interface Assembly 2-281
Replace the Alarm Interface Panel 2-282
CHAPTER 3 Transient Conditions 3-1
3.1 Transients Indexed By Alphabetical Entry 3-1
3.2 Trouble Notifications 3-3
3.2.1 Condition Characteristics 3-3
3.2.2 Condition States 3-4
3.3 Transient Conditions 3-4
3.3.1 ADMIN-DISABLE 3-4
3.3.2 ADMIN-DISABLE-CLR 3-4
3.3.3 ADMIN-LOCKOUT 3-4
3.3.4 ADMIN-LOCKOUT-CLR 3-4
3.3.5 ADMIN-LOGOUT 3-5
3.3.6 ADMIN-SUSPEND 3-5
3.3.7 ADMIN-SUSPEND-CLR 3-5
3.3.8 AUD-ARCHIVE-FAIL 3-5
3.3.9 AUTOWDMANS 3-5
3.3.10 BLSR-RESYNC 3-5