Cisco ONS 15454 - Page 528

4-40
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-6016 The card mode cannot be changed to Fibre Channel Line Rate
if the port media type is FICON 1Gbps ISL or FICON 2Gbps
ISL.
Refer to the error message text.
EID-6017 The destination of a {0} route cannot be a node IP address. A node IP address cannot be the destination
for a static route.
EID-6018 The destination of a {0} route cannot be the same as the subnet
used by the node.
Refer to the error message text.
EID-6019 The destination of a static route cannot be 255.255.255.255 The network address such as
255.255.255.255 is not valid. Enter a valid
address.
EID-6020 The destination of a static route cannot be the loopback network
(127.0.0.0/8).
Refer to the error message text.
EID-6021 The subnet mask length for a non default route must be between
8 and 32.
Length of subnet mask must be within the
specified range.
EID-6022 The subnet mask length for a default route must be 0. Refer to the error message text.
EID-6023 The destination of a {0} route cannot be an internal
network{1}.
The destination of a static route must not be
an internal network.
EID-6024 The destination of a {0} route cannot be a class D (224.0.0.0/4)
or class E (240.0.0.0/4) address.
The destination of a static route must not be
a class D or class E address.
EID-6025 The destination of a {0} route cannot be a class A broadcast
address (x.255.255.255/8).
The destination of a static route must not be
a class A broadcast address. It should be
(xxx.0.0.0).
EID-6026 The destination of a {0} route cannot be a class B broadcast
address (x.x.255.255/16).
The destination of a static route must not be
a class B broadcast address.
EID-6027 The destination of a {0} route cannot be a class C broadcast
address (x.x.x.255/24).
The destination of a static route must not be
a class C broadcast address.
EID-6028 The destination of a {0} route cannot be the subnet broadcast
address associated with a node IP address.
The destination of a static route must not be
a subnet broadcast address of a node IP.
EID-6029 The next hop of a static route cannot be the same as the
destination of the route or an internal network{0}.
Static route must have the default route as
the next hop, and not destination of the
route or internal network.
EID-6030 The next hop of a static default route must be the provisioned
default router.
The default route is selected for networks
that do not have a specific route.
EID-6031 No more static routes can be created. You have reached the maximum number of
static routes.
EID-6032 This static route already exists. Refer to the error message text.
EID-6033 A previous operation is still in progress. Another operation is in progress. You must
try after sometime.
EID-6035 The parent entity does not exist. Refer to the error message text.
EID-6036 The parent PPM entity does not exist. Create a parent entity for the PPM.
EID-6037 This equipment type is not supported. CTC does not support this equipment.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description