4-46
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
WID-6146 Deleting the protection group while in a switched state might
cause a loss of traffic. It is recommended that you verify switch
states before proceeding.
Refer to the warning message text.
EID-6147 The protection switch could not be performed. A protection switch cannot be performed
during protection operations like manual
switch, lockout, and so on.
EID-6148 A server trail is present. Refer to the warning message text.
EID-6149 The LAPD MTU size must be greater than or equal to the {0}
LSP buffer size {1}. Alternatively, you can decrease the {0}
LSP buffer size to {2}.
Refer to the error message text.
EID-6150 The value is out of range. Enter a value that is within the range.
EID-6151 The minimum span loss must be less than the maximum span
loss.
Refer to the error message text.
EID-6152 The "Use NTP/SNTP Server" field is checked. Enter the
NTP/SNTP server IP address or server name.
Enter the NTP/SNTP server name. To leave
this field empty, uncheck the “Use
NTP/SNTP Server" and proceed.
EID-6153 The maximum frame size is invalid. Refer to the error message text.
EID-6154 To combine unidirectional two-port provisioning and
autonegotiation on the same port, autonegotiation must be set
first.
Refer to the error message text.
EID-6155 Transponder mode cannot be provisioned with circuits on the
card.
Refer to the error message text.
EID-6156 The transponder configuration is invalid. The transponder is not configured properly.
EID-6157 The watermark values are either out of range or inconsistent. Enter valid watermark values.
EID-6179 The 1+1 protection group is not optimized. Refer to the error message text.
EID-6196 The equipment has failed or is missing. Operation is requested on a failed or
missing equipment.
EID-6197 Attributes cannot be changed when the port administrative state
is {0}.
You cannot change the attributes when the
port is in the specified administrative state.
WID-6204 This action will cause the node to reboot. When provisioning in
single-shelf mode, Shelf {0} of the node that you connect to
must be properly preprovisioned or you will lose traffic.
Use the LCD to return to single-shelf mode. CTC cannot be
used for this.
Changing from subtended shelf mode to single-shelf mode
could be traffic-affecting.
Refer to the warning message text.
EID-6205 The interlink port is not provisioned. The user creates an ADM peer group
without interlink ports.
EID-6206 The ADM peer group has already been created on the peer card. The user creates an ADM peer group
involving an ADM card inserted in a peer
group.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page