4-51
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 4 Error Messages
EID-6298 The alarm type already exists. Refer to the error message text.
EID-6299 The alarm type does not exist. Refer to the error message text.
EID-6300 Selective auto negotiation is allowed only when
selected speed and duplex modes are non-auto.
Click "Reset" to revert the changes.
Refer to the error message text.
WID-6301 Selective auto negotiation applies only to copper SFPs. Refer to the error message text.
EID-6302 Users are not allowed to perform this operation. When logged in as a maintainence user
provisioning operation is not allowed.
EID-6303 The ITU-T G.709 configuration cannot be disabled
when Fast Protection is enabled.
Refer to the error message text.
1. EID-3159 can appear if you attempt to perform another switching operation within a certain time interval. This interval is an algorithm of three seconds
per working card in the protection group. The maximum interval is 10 seconds.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description
To Next Page
Loading...
