DMD1050TS Satellite Modem Board
Revision 1
Preface ii MN-DMD1050TS
Related Documents
The following documents are referenced in this manual:
• Department of Defense (DOD) MIL-STD-188-114A, Electrical Characteristics of Digital
Interface Circuits
• Department of Defense (DOD) MIL-STD-188-165A, Interoperability and Performance
Standards for SHF Satellite Communications PSK Modems (FDMA Operation) (dated
November 2005)
• INTELSAT Earth Station Standards IESS-308, -309, -310, and -315
• EUTELSAT SMS
Military Standards
References to “MIL-STD-188” apply to the 114A series (i.e., MIL-STD-188-114A), which provides
electrical and functional characteristics of the unbalanced and balanced voltage digital interface
circuits applicable to both long haul and tactical communications. Specifically, these references
apply to the MIL-STD-188-114A electrical characteristics for a balanced voltage digital interface
circuit, Type 1 generator, for the full range of data rates. For more information, refer to the
Department of Defense (DOD) MIL-STD-188-114A, Electrical Characteristics of Digital Interface
Circuits.
Warnings, Cautions, and Notes
A WARNING GIVES INFORMATION ABOUT A POSSIBLE HAZARD THAT MAY
CAUSE DEATH OR SERIOUS INJURY.
A CAUTION gives information about a possible hazard that MAY CAUSE INJURY
or PROPERTY DAMAGE.
A NOTE gives important information about a task or the equipment.
A REFERENCE directs you to additional information about a task or the
equipment.
Examples of Multi-Hazard Notices
To Next Page
Loading...
