DMD1050TS Satellite Modem Board
Revision 1
Appendix H H–2 MN-DMD1050TS
H.4.4 Enter the Upgrade Code
Make sure to enter the code correctly.
After three unsuccessful attempts to enter
a code, the modem locks out the upgrade and demonstration capability. To
continue after the lock out, you must cycle power on the modem.
1. Enter the upgrade code from the terminal port:
a. On the Enter Selection Number line, type 45
b. Press Enter
c. Enter the new code
d. Press Enter
If the code entered is correct, the CODE ACCEPTED message shows. The modem upgrade is
finished.
Otherwise, the INVALID CODE message shows. Repeat all of Step 1, and make sure the code
entered is correct.
To Next Page
Loading...
