Comtech EF Data DMD1050TS - Carrier Request to Send (RTS

DMD1050TS Satellite Modem Board
Revision 1
Appendix B B–2 MN-DMD1050TS
B.6 Carrier Request to Send (RTS)
Use the interface to turn Modulator output off before reprogramming modulator functions that can
change the output spectrum. After the change, you must enter Yes to re-enable output.
When using the terminal, turn the modulator off while reprogramming modulator functions that
can change the output spectrum. After reprogramming, you must turn the output on manually.
Additionally, Request to Send (RTS) mode enables the modulator’s output based on the RTS
lead of the data interface. When RTS is enabled on the data interface, the modulator turns the
carrier on. When the RTS is disabled, the modulator turns the carrier off.