DMD1050TS Satellite Modem Board
Revision 1
Rear Panel Interface 4–1 MN-DMD1050TS
Chapter 4. Rear Panel Interface
This section discusses the electrical interfaces on the rear panel. All locations are as seen from
the rear of the unit, unless specified otherwise.
4.1 DMD1050TS Connections
All DMD1050TS connections are made to labeled connectors located on the Modem Board.
See Figure 4-1, Figure 4-2, Figure 4-3, and Figure 4-4.
You must use the correct connector to make any connection to the DMD1050TS. See Appendix E
for information about the connectors that are used with the DMD1050TS.
The DMD1050TS consists of these assemblies:
• RF Board (PL-0021834)
• Baseband Modem Board (PL-0022534)
• FIPs Security Module (PL-0000192)
To Next Page
Loading...
