DMD1050TS Satellite Modem Board
Revision 1
Appendix G G–1 MN-DMD1050TS
Appendix G. Strap Codes
G.1 Introduction
The Strap Code is a key that quickly sets many of the modem parameters. For quick setup, the
Strap Codes are very helpful. Use Table G-1. Strap Codes (Dis = Disable), for a list of available
strap codes.
When a Strap Code is entered, the modem is configured automatically for the code’s
corresponding data rate, overhead, code rate, framing, scrambler type and modulation. For
example, on the Web interface page,
<Transmit> <General/IF>, enter 26 in the Strap Code: field.
The modem is then configured automatically to the parameters shown in
Table G-1, in the
highlighted row for Strap Code 26.
Table G-1. Strap Codes (Dis = Disable)
Strap Code (Decimal)
Data Rate (Kbps)
Overhead
Code Rate
Type
Framing Type
Scrambler Type
Reed-Solomon
Modulation
Mode
To Next Page
Loading...
