DMD1050TS Satellite Modem Board
Revision 1
TRANSEC Module SSH CLI Operation 9–4 MN-DMD1050TS
9.2.2.1 Save
Before you end the CLI session, make sure to save changes to permanent storage. Unsaved
changes remain active as long as the modem remains in operation; however, unsaved changes
are lost if, for example, the unit loses power.
Use the S command on any menu to save changed parameters. A prompt asks you to confirm
that all changes will be permanent:
9.2.2.2 Log out
Use the L command to log out of a CLI session. A prompt asks you to confirm that the session
should be ended:
9.2.3 Main Menu
Figure 9-2. Main Menu Example
To Next Page
Loading...
