DMD1050TS Satellite Modem Board
Revision 1
Theory of Operation 3–16 MN-DMD1050TS
3.7.1.9 Packet Statistics
These statistics are available from the Monitor Menu, when the Ethernet Data Interface is
selected.
• Total Packets: shows the total number of Ethernet packets received from the satellite
• Error Packets: shows the total number of Ethernet packets received from the satellite
that had errors
• Packet Error Rate: shows the Ethernet Packet Error Rate (PER) from the satellite
• Packet Statistics Reset: allows you to reset the Ethernet Total Packets and Ethernet
Error Count by pressing Enter
• Link Status: These statuses are available in the Monitor Menu/Link Status Sub-Menu,
when the Ethernet Data Interface is selected:
o Port 2 Status: shows the current status of LAN Port 1
o Port 3 Status: shows the current status of LAN Port 2
o For each of these ports, the status can have one of these values/meanings:
Down: link is down
Unresolved: cannot agree on connection speed
10 Mbps Half: connected at 10 Base-T Half Duplex
10 Mbps Full: connected at 10 Base-T Full Duplex
100 Mbps Half: connected at 100 Base-T Half Duplex
100 Mbps Full: connected at 100 Base-T Full Duplex
If all LAN Ports are down, a Tx Data Activity Minor Alarm is generated.
If the Wide Area Network (WAN) Port is down, a Tx and Rx Ethernet WAN Major Alarm is
generated.
To Next Page
Loading...
