CTM 360y - Safety Guidelines; Installation and Maintenance; Operation; Electrical Shock

Instruction Manuals: Installation, Operators Maintenance Standard 360y Label Applicator
xii
SAFETY GUIDELINES
Installation and Maintenance
Operation
Electrical Shock
CAUTION: Do not unplug any connector on the applicator when the main power is on.
WARNING:
• Improper use of the applicator can lead to personal injury or property damage!
• During installation,
o Check for visible shipment damage and immediately inform your distributor.
o Provide a supply disconnecting device and an emergency stop device. Install both devices in a way
that they are easily reachable.
o Ensure the machine cannot tip over.
o Check if all safety functions are working properly.
• Use only original replacement parts.
• Do not operate in a hazardous location—an environment where flammable or explosive gasses or
materials are present. Installation in a hazardous location might lead to an explosion causing personal
injury or equipment damage.
• Do not use in direct contact with food products.
• Disconnect from power when performing any type of maintenance.
WARNING:
• Danger of crushing between applicator and conveyor!
• Keep hands and clothing clear of applicator while running.
• Access to the running applicator must be prevented by the protective guarding of the system.
• Do not remove or attempt to disable any protective guarding of the system or operate the applicator if the
protective guarding is damaged.
• Observe all safety and warning labels on the equipment for safe operation of the system.
CAUTION: Do not remove or obstruct any warning or caution labels, or instruction labels on the equipment. If
the labels become removed, damage, or worn they must be replaced immediately.
WARNING:
• The applicator connects to mains voltage. Contact with electrically live components could lead to lethal
shock or burns!
• Before attempting any service or repair, disconnect from the main power supply and isolate from any
additional external power supply sources.
• Keep the applicator dry. If liquid gets into the applicator remove power immediately and notify a service
technician.