CTM 360y - Reboot Required; Stop Input; End of Web Alarm; E-Stop Input

Display Faults
Maintenance Manual: Standard 360a Model Y (360y) Label Applicator
18
08/2022
Reboot Required
If a Controller Reboot is required, the alarm screen in Figure [30] displays.
Stop Input
The Stop Input Alarm Screen [106] displays if the stop input is active while the
applicator is enabled.
End of Web Alarm
The End of Web sensor detects no media at the end of a cycle [107].
E-Stop Input
The E-Stop Input Alarm Screen [108] displays if the E-Stop is set while the applicator
is enabled and in motion.
Fault Correction
Unathourized personell should not carry out diagnoses and fault correction work. If the instructions displayed on the HMI do not clear
the fault, further troubleshooting may be required. Call your technician or authorised service person.
[31] Reboot Required Fault
[32] Stop Input Fault
[33] End of Web Fault
[34] E-Stop Fault