Installation Manual: Standard 360a Model Y (360y) Label Applicator
17
Decommissioning the Applicator
DECOMMISSIONING THE APPLICATOR
When the applicator no longer functions correctly, it needs to be decommissioned properly. The applicator needs to be taken down
from its permanent mount and then disposed of. There are certain regulations that need to be followed when this happens.
Dismantling the Applicator
1. Power off the applicator.
2. Disconnect all air connections.
3. Unplug power cable from the outlet.
4. Unplug all other cables connected to the applicator.
5. Put the applicator in an upright position.
6. Remove all sensors, if needed.
7. Dismount the applicator from its previously permanent location.
8. Dispose of the applicator
Disposing of the Applicator
When ready to dispose of your applicator adhere to local state and federal restrictions.
CAUTION: When lowering the applicator from the stand, do NOT lift by the dancer arm because it is held on by
a spring. It is delicate and can be bent and/or broken. Refrain from lifting by any other part on the front of the
applicator as these can also get damaged in the process.
WARNING: Applicators can weigh around 130lb or more. If there is no access to a pump lift pallet jack or
powered system to lower the applicator from the stand, more than one person will be needed to lift and remove the
applicators to the base system. Applicator may be unbalanced to the front and Servo Slide sides. Follow to your
company’s weightlifting guidelines!
To Next Page
Loading...
