FC 300 Design Guide
How to Program
Function:
View the error code and look up its m eaning in the
Troubleshooting chapte r of the FC 300 Desig n Guide.
15-31 Fault Log: Value
Array [10]
Range:
-32767 - 32767
*
0
Function:
View an extra description of the error. This
parameter is mostly used in comb
ination with
alarm 38 ‘internal fault ’.
15-32 Fault Log: Time
Array [10]
Range:
0 - 2147483647
*
0
Function:
View the time when the logged event occurred.
Time is measured in seconds from adjustable
frequency drive start-up.
" 15-4* Drive Identi fication
Parameters containing read only information
about the hardware and software configuration
of the adjustable freque n cy drive.
15-40 FC Type
Function:
View the FC type. The read -out is identical
to the FC 300 Series power field of the typ e
code definition, characters 1-6.
15-41 Power Section
Function:
View the FC type. The read -out is identical
to the FC 300 Series power field of the typ e
code definition, characters 7-10.
15-42 Voltage
Function:
View the FC type. The read -out is identical
to the FC 300 Series power field of the typ e
code definition, characters 11-12.
15-43 Software Version
Function:
View the combined SW version (or ‘package
version’) consisting of power SW and control SW.
15-44 Ordered Typecode String
Function:
Viewthetypecodestringusedforre-ordering
theadjustablefrequencydriveinits
original configuration.
15-45 Actual Typecode String
Function:
Viewtheactualtypecodestring.
15-46 Adj Freq Dr Ordering No.
Function:
View the 8 -digit ordering number used for
re-ordering the adjustable frequency drive
in its original configuration.
15-47 Po wer Ca rd Ord ering No.
Function:
View the power card ordering number.
15-48 LCP ID Num.
Function:
View the LCP ID number.
15-49 SW ID Control Card
Function:
View the control card software version number.
15-50 SW ID Power Card
Function:
View the power card software version number.
15-51 Adj Freq Dr Serial No.
Function:
View the adjustable frequency drive serial number.
15-53 Power Card Serial Number
Function:
View the power card serial num be r.
*
default setting ()display text []value for use in communication via serial communication port
243
MG.33.B
6.22 - V LT is a registered Danfoss trademark
To Next Page
Loading...
Need help?
General