User Interface
60
DX8210 Barcode Scanner
Distance from PS Line to Tx Line
Enter the distance along the Y axis from the PS (photoelectric sensor) to the TX Line
(transmit).
Replicate same code when symbologies don't match
Select the check box to enable a further code filter condition according to which a
read code is added to the list or discarded. This parameter is available if the Code
Filter Depth value is other than zero or if the Code Filter value is Tx Line.
In addition to the inherent content and code length comparison, this parameter
compares the code type (symbology). If the current code being read is identical to
any code contained in the list by: content, length and type, the current code is
discarded. If not, the current code is accepted and added to the list in the first
position; the remaining codes in the list are shifted. If the list is full the oldest code
in the list will be flushed.
Replicate same code when X positions don't match
Select the check box to enable a further code filter condition according to which a
read code is added to the list or discarded. This parameter is available if the Code
Filter Depth value is other than zero or if the Code Filter value is Tx Line.
In addition to the inherent content and code length comparison, this parameter
compares the X coordinate code position. If the current code being read is identical
to any code contained in the list by: content, length and X coordinate code position,
the current code is discarded. If not, the current code is accepted and added to the
list in the first position; the remaining codes in the list are shifted. If the list is full
the oldest code in the list will be flushed.
Replicate same code when Y positions don't match
Select the check box to enable a further code filter condition according to which a
read code is added to the list or discarded. This parameter is available if the Code
Filter Depth value is other than zero or if the Code Filter value is Tx Line.
In addition to the inherent content and code length comparison, this parameter
compares the Y coordinate code position. If the current code being read is identical
to any code contained in the list by: content, length and Y coordinate code position,
the current code is discarded. If not, the current code is accepted and added to the
list in the first position; the remaining codes in the list are shifted. If the list is full
the oldest code in the list will be flushed.
Replicate same code when Z positions don't match
Select the check box to enable a further code filter condition according to which a
read code is added to the list or discarded. This parameter is available if the Code
Filter Depth value is other than zero or if the Code Filter value is Tx Line
Tracking starts 10 cm [4 inches] before and stops 10 cm [4 inches] after the Reading
Area in order to ensure the barcode is assigned to the correct package.
To Next Page
Loading...
