Datalogic Gryphon I GD4132 User Manual

ENTER/EXIT PROGRAMMING MODE
98 Gryphon™ I GD4132/GM4102/GBT4102
Sleep Mode Timeout
This feature sets the amount of time that the reader will be idle before it enters
into a low power Sleep Mode. When in Sleep Mode the reader can no longer
receive commands from the Host or base station until it is woken up again by a
trigger pull or being placed into a base station.
In order for the reader to enter Sleep Mode, the following conditions must be
me
t:
Corded version (GD4132 only): RS-232 interface and trigger single, trigger multi-
ple or trigger pulse.
Mobile version (GM4102 only): Sleep state is allowed only on the handheld (not on
the base) when trigger single, trigger multiple or trigger pulse are set, and
when the reader is not charging the battery.
This feature is not applicable to the Gryphon BT models
Sleep Mode Timeout = Disable
DEFAULT
Sleep Mode Timeout = 1 Second
Sleep Mode Timeout = 2 Seconds
Sleep Mode Timeout = 3 Seconds
$
Sleep Mode Timeout = 4 Seconds

Datalogic Gryphon I GD4132 Specifications

General

Brand	Datalogic
Model	Gryphon I GD4132
Category	Barcode Reader
Language	English