ENTER/EXIT PROGRAMMING MODE
106 Gryphon™ I GD4132/GM4102/GBT4102
Stand Mode Triggered Timeout
This feature specifies the time to remain in Trigger Single mode after the trig-
ger is pulled while in Stand Mode.
This timeout is only used when the Scan Mode is configured as Stand
Mode.
Stand Mode Triggered Timeout = 0.5 Seconds
DEFAULT
Stand Mode Triggered Timeout = 1.5 Seconds
Stand Mode Triggered Timeout = 2 Seconds
Stand Mode Triggered Timeout = 3 Seconds
Stand Mode Triggered Timeout = 4 Seconds
Stand Mode Triggered Timeout = 6 Seconds
To Next Page
Loading...
