References
314 Gryphon™ I GD4132/GM4102/GBT4102
LED and Beeper Control
ESC [ 0 q
Emit short High tone + short delay
ESC [ 1 q
Emit short Low tone + short delay
ESC [ 2 q
Emit long Low tone + short delay
ESC [ 3 q
Emit good read tone
ESC [ 4 q
Emit bad tx tone
ESC [ 5 q
Wait 100 ms
ESC [ 6 q
Turn on the green LED
ESC [ 7 q
Turn off the green LED
ESC [ 8 q
Turn on the green spot
ESC [ 9 q
Turn off the green spot
ESC [ 0 r
Beep for Find me function (new)
ESC [ 1 r
Power-off (new)
The LED control escape sequences are intended to activate the LEDs for short
periods of time and can be used in combination with the Beeper. The LED and
Beeper will be controlled by the system after the entire command sequence is
interpreted.
Example:
ESC [ 6 q ESC [ 3 q ESC
[ 7 q
Turns on the green LED, emits a good read tone, and turns off the
green LED.
ESC [ 6 q ESC [ 5 q ESC
[ 7 q
Turns on the green LED for 100 ms and then turns off the green LED.
To Next Page
Loading...
Need help?
General
