ENTER/EXIT PROGRAMMING MODE
94 Gryphon™ I GD4132/GM4102/GBT4102
Character Conversion
Character conversion is an eight byte configuration item. The eight bytes are 4
character pairs represented in hexadecimal ASCII values. The first character in
the pair is the character that will be converted. The second character in the pair
is the character to convert to. If the character to convert in a pair is FF, then no
conversion is done.
Configure Character Conversion
DEFAULT
0xFFFFFFFFFFFFFFFF
(No character conversion)
If less than the expected string of 16 characters are selected, scan the
ENTER/EXIT barcode twice to accept the selections and exit Programming
Mode.
To Next Page
Loading...
