Datalogic Gryphon I GD4132 - Codablock F AIM Check; Codablock F Length Control

ENTER/EXIT PROGRAMMING MODE
168 Gryphon™ I GD4132/GM4102/GBT4102
Codablock F AIM Check
Specifies if Check Digit calculation algorithm is AIM compliant or not.
Codablock F AIM Check = Disable
Codablock F AIM Check = Enable Check C
DEFAULT
Codablock F Length Control
This feature specifies either variable length decoding or fixed length decoding
for the Codablock F symbology.
Variable Length: For variable length decoding, a minimum and maximum length
may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
DEFAULT
Codablock F Length Control = Variable Length
Codablock F = Fixed Length