ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
169
Codablock F Set Length 1
Specifies one of the barcode lengths for Codablock F Length Control. Length 1
is the minimum label length if in Variable Length Mode, or the first fixed length
if in Fixed Length Mode. Length includes the barcode’s data characters only.
Characters can be set from 03 to 255 characters.
Table 6 provides some examples for setting Length 1. See page 294 for
detailed instructions on setting this feature.
Table 6. CODABLOCK F Length 1 Setting Examples
STEP ACTION EXAMPLES
1 Desired Setting
03 Characters 07 Characters 15 Characters 50 Characters
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT CODABLOCK F LENGTH 1 SETTING
4
Scan Three Characters From
Appendix D, Keypad
‘0’, ‘0’ and ‘3’ ‘0’, ‘0’ and ‘7’ ‘0’,‘1’ and ‘5’ ‘0’,‘5’ AND ‘0’
5 Scan ENTER/EXIT PROGRAMMING MODE
Select Codablock F Length 1 Setting
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
03 = Length 1 is 3 Characters
To Next Page
Loading...
Need help?
General
