Datalogic Gryphon I GD4132 - Double Read Timeout

ENTER/EXIT PROGRAMMING MODE
96 Gryphon™ I GD4132/GM4102/GBT4102
Double Read Timeout
Double Read Timeout prevents a double read of the same label by setting the
minimum time allowed between reads of labels of the same symbology and
data. If the unit reads a label and sees the same label again within the specified
timeout, the second read is ignored. Double Read Timeout does not apply to
scan modes that require a trigger pull for each label read.
Double Read Timeout = 0.1 Second
Double Read Timeout = 0.2 Second
Double Read Timeout = 0.3 Second
Double Read Timeout = 0.4 Second
Double Read Timeout = 0.5 Second
Double Read Timeout = 0.6 Second
DEFAULT
Double Read Timeout = 0.7 Second