Datalogic Gryphon I GD4132

Setup
34 Gryphon™ I GD4132/GM4102/GBT 4102
Customizing Configuration Settings
Configure Interface Settings
If after scanning the interface barcode from the previous table, your installation
requires you to select options to further customize your reader, turn to the
appropriate section for your interface type in "Configuration Using Barcodes"
starting on page 39.
• "RS-232 ONLY Interface" on page 43
• "RS-232/USB-Com Interfaces" on page 48
• "Keyboard Interface" on page 57
• "USB-OEM Interface (available with special cable)" on page 69
• "IBM 46XX Interface (AVAILABLE WITH SPECIAL CABLE)" on page 71 (ava
il-
able with special cable)
• "Wand Emulation Interface" on page 75
Global Interface Features
See "Global Interface Features" on page 41 for settings configurable by all inter-
face types.
Configuring Other Features
If your installation requires different programming than the standard factory
default settings, the following sections of this manual allow configuration of
non-interface-specific settings you might require:
Reading Parameters
: Reading Parameters include programming for scanning,
beeper and LED indicators and other universal settings.
Code Selection
: Includes options concerning the barcode label types (symbolo-
gies). These settings allow you to enable/disable symbologies, set label
le
ngths, require check digit, etc.
Wireless Features
: Contains programming options for RF and Bluetooth models
only.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and
Keyboard interfaces by scanning the following label.
Transmit Software Version