Configuration Using Barcodes
40
Gryphon™ I GD4132/GM4102/GBT 4102
Symbology-specific parameters:
• "Code Selection" on page 111 provides configuration of a personalized
mix of codes, code famili
es and their options.
Model-specific parameters:
• "Wireless Features" on page 259 offers configuration of radio control
parameters for RF and Bluetooth models.
Reading Configuration Barcodes
You must first enable your reader to read barcodes in order to use
this section. If you have not done this, go to
Setup, starting on
page 17
and complete the appropriate procedure.
To program features:
1. Scan the ENTER/EXIT PROGRAMMING barcode, available at the top of each
programming
page, when applicable.
2. Scan the barcode to set the desired pr
ogramming feature. You may need
to cover unused barcodes on the page, and possibly the facing page, to
ensure that the reader reads only the barcode you intend to scan.
3. If additional input paramete
rs are needed, go to Appendix D, Keypad, and
scan the appropriate characters from the keypad.
Additional information about many features can be found in the “Ref-
erences” chapter.
If you make a mistake before the last cha
racter, scan the CANCEL bar-
code to abort and not save the entry
string. You can then start again
at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PRO-
GRAMMING barcode to exit Programming Mode.
For detailed descriptio
ns, programming information and examples for setting
selected configuration items, see References, starting on page 283.
To Next Page
Loading...
