ENTER/EXIT PROGRAMMING MODE
100 Gryphon™ I GD4132/GM4102/GBT4102
LED AND BEEPER INDICATORS
Power On Alert
Disables or enables the indication (from the Beeper) that the reader is receiving
power.
Power On Alert = Disable (No Audible Indication)
Power On Alert = Four Beeps
DEFAULT
Good Read: When to Indicate
This feature specifies when the reader will provide indication (beep and/or flash
its green LED) upon successfully reading a barcode. .
Indicate Good Read = After Decode
Indicate Good Read = After Transmit
Indicate Good Read = After CTS Goes Inactive, Then Active
This option, which uses CTS, is only valid for RS-232 interfaces.
This item is not configurable for the GM4102/GBT 4102 models.
To Next Page
Loading...
