ENTER/EXIT PROGRAMMING MODE
Product Reference Guide
97
Double Read Timeout — continued
Double Read Timeout = 0.8 Second
Double Read Timeout = 0.9 Second
Double Read Timeout = 1 Second
Label Gone Timeout
This feature sets the time after the last label segment is seen before the reader
prepares for a new label. The timeout can be set within a range of 10 millisec-
onds to 2,550 milliseconds (2.55 seconds) in 10ms increments. Label Gone
Time
out does not apply to scan modes that require a trigger pull for each label
that is read. See page 304 in “References” for detailed instructions and exam-
ples for setting this feature.
Select Label Gone Timeout Setting
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
To Next Page
Loading...
