About the Reader
Product Reference Guide
11
About the Reader
Typically, units are factory-programmed for the most common terminal and
communications settings. If you need to modify any programmable settings,
custom configuration can be accomplished by scanning the programming bar
-
codes within this guide.
Several models of the Gryphon are available, and are covered in this manual:
• Gryphon I GD4132 - Corded linear imager barcode reader
• Gryphon I GM4102 - Cordless linear imager barcode reader with Datalogic
STAR™.
• Gryphon I BT 4102 - Model with Bluetooth options.
Programming can alternatively be performed using the Datalogic Aladdin™
Configuration application which is downloadable from the Datalogic website
listed on the back cover of this manual. This multi-platform utility program
allows device configuration using a PC. It communicates to the device using a
serial or USB cable and can also create configuration barcodes to print.
Advancements in the LED technology used in the imager-based readers signifi-
cantly improve the illumination of the target field of view, resulting in higher
scan efficiency. Whether used in Single Trigger or Continuous Mode, the ergo
-
nomic design of the reader will help to promote comfortable handling during
extended periods of use.
See "Interface Selection" on page 30 for a listing and descriptions of available
interface sets by model type.
To Next Page
Loading...
