ENTER/EXIT PROGRAMMING MODE
108 Gryphon™ I GD4132/GM4102/GBT4102
Stand Mode Sensitivity
Sets the sensitivity level for stand mode wakeup. Choices are low, medium and
high.
Stand Mode Sensitivity = Low
Stand Mode Sensitivity = Medium
DEFAULT
Stand Mode Sensitivity = High
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state
once the state is entered. The range for this setting is from 1 to 255 seconds in
1-second increments. See page 307 in “References” for descriptions of each
feature
Select Scanning Active Time Setting
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL
DEFAULT
005 = Scanning is active for 5 Seconds
To Next Page
Loading...
