Customizing Configuration Settings
Product Reference Guide
35
Resetting the Product Configuration to Defaults
Restore Custom Defaults
If you aren’t sure what programming options are in your imager, or you’ve
changed some options and want to restore the Custom Default Configuration
that may have been saved in the scanner, scan the Restore Custom Default
Configuration barcode below. This will restore the custom configuration for the
currently active interface.
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the
imager for the correct interface before scanning this label.
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan either the
Restore USA Factory Configuration barcode or the Restore EU Factory Configu-
ration barcode below. Both labels restore the scanner configuration to the fac-
tory settings, including the interface type. The USA label restores Label IDs to
th
ose historically used in the USA. The EU label restores Label IDs to those his-
torically used in Europe. The Label ID sets for USA and EU are shown in the
“Label ID” section on page 83 of this manual.
Restore USA Factory Configuration
Restore EU Factory Configuration
The programming items listed in the following sections show the factory
default settings for each of the menu commands.
To Next Page
Loading...
Need help?
General
