Datalogic Gryphon Series

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 99
Stand Operation
Specifies the behavior of the reader when stationary in a stand.
There are two conditions which cause the reader to switch to Stand Mode:
1. The reader is configured to switch to Stand Mode when stationary.
2. The reader is placed into the cradle of the base station.
Below are further options concern
ing Stand Operation.
Ignore Autorecognition. Disables mode switching when the reader is placed in a stand.
Switch to Stand Mode. Automatically switches the reader to Stand Mode when the reader is
placed in the stand.
Switch to Flashing. Automatically switches the reader to Flash Mode when the reader is placed
in the stand.
Switch to Always On. Automatically switches the reader to Always On mode when the reader is
placed in the stand
.
Do Not Change Mode
Change to Stand Mode
Change to Always On
Change to Flashing
$CSMSD00(
CR)
$CSMSD01(
CR)
DEFAULT
$CSMSD02(CR)
$CSMSD03(CR)