Datalogic Gryphon Series User Manual

Enter/Exit Programming Mode RS-232/USB-Com Interfaces
50 Gryphon™ I GD44XX / GBT4400/GM440X
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII characters or any hex
value from 0 to 0xFF can be selected. See page 256 for more information.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII characters or any hex
value from 0 to 0xFF can be selected. Se
e page 257 for more information.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
Data Bits has been set as
7 Data Bits.
Select ACK Character Setting
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with normal
operation of these characters. 8-bit data is not recognized when the option
Data Bits has been set as
7 Data Bits.
Select NAK Character Setting
$CR2AC
DEFAULT
0x06 ‘ACK’ Character
$CR2NA
DEFAULT
0x15 ‘NAK’ Character

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux