Datalogic Gryphon Series User Manual

Enter/Exit Programming Mode Reading Parameters
108 Gryphon™ I GD44XX / GBT4400/GM440X
Multiple Labels Ordering by Code Symbology
This feature allows you to specify the order multiple labels are transmitted by symbology type,
when Multiple Labels per Frame is enabled. See page 283 in “References” for detailed
information on setting this feature.
Multiple Labels Ordering by Code Length
Specifies the transmission ordering by code length, when Multiple Labels per Frame is enabled.
Select Symbologies for Multiple Labels Ordering
To configure this feature, s
can the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
a
t left followed by the digits From the alphanumeric
characters In Appendix d, keypad representing your
desired Character(s). end by scanning the enter/exit bar
code again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start again at
the beginning.
CANCEL
$CSNMS
~
DEFAULT
000000000000 = Random order
Multiple Labels Ordering = Disable
Transmit Increasing Length Order Transmit Decreasing Length Order
DEFAULT
$CSNMT00(CR)
$CSNMT01(CR)
$CSNMT02(CR)

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux