Datalogic Gryphon Series User Manual

Aztec Code Enter/Exit Programming Mode
Product Reference Guide 205
Aztec Code Set Length 1
Specifies one of the bar code lengths for Aztec Code Length Control. Length 1 is the minimum
label length if in V
ariable Length Mode, or the first fixed length if in Fixed Length Mode.
Characters can be set from 0001 to 3,832 characters in increments of 0001 (pad with zeroes).
See page 265 for detailed instructions on setting this feature.
Select Aztec Code Length 1 Setting
To configure this feature, sc
an the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
a
t left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start again at
the beginning.
CANCEL
$CAZL1
~
DEFAULT
0001 = Length 1 is 1 Character

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux