Datalogic Gryphon Series User Manual

Setup Customizing Configuration Settings
34 Gryphon™ I GD44XX / GBT4400/GM440X
Resetting the Product Configuration to Defaults
Restore Custom Defaults
If you aren’t sure what programming options are in your imager, or you’ve changed some
options and want to restore the Custom Default Configuration that may have been saved in the
scanner, scan the Restore Custom Default Configuration bar code below. This will restore the
custom configuration for the currently active interface.
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan either the Restore USA
Factory Configuration bar code or the Restore EU Factory Configuration bar code below. Both
labels restore the scanner configuration to the factory settings, including the interface type. The
USA label restores Label IDs to those historically used in the USA. The EU label restores Label
IDs to those historically used in Europe. The Label ID sets for USA and EU are shown in the
“Label ID Control” section on page 81 of this manual.
The programming items listed in the following sections show
the factory default settings for
each of the menu commands.
Custom defaults are based on the interface type. Configure the imager
for the correct interface before scanning this label.
Restore USA Factory Configuration
Restore EU Factory Configuration
Restore Custom Default Configuration
$P,HA00,P(CR)
$P,AE,P(CR)
$P,Ae,P(CR)

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux