Datalogic Gryphon Series User Manual

Enter/Exit Programming Mode Reading Parameters
104 Gryphon™ I GD44XX / GBT4400/GM440X
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger
single mode.The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 280 in “References” for a description of this feature.
Aiming Pointer = Disable
Aiming Pointer = Enable
$CTAAP00(CR)
$CTAAP01(CR)
DEFAULT
Aiming Off After Decoding
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING
MODE
bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters
in
Appendix D, Keypad representing your desired
character(s). End by scanning the ENTER/EXIT bar code.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start again at
the beginning.
CANCEL
DEFAULT
LSTM00
LSTM
~

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux