Datalogic Gryphon Series User Manual

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 101
Stand Mode Illumination Off Time
Specifies the amount of time reader illumination stays off after pulling the trigger when in Stand
Mode. The configurable range is 01 to 32 by 01 in increments of 500ms (500ms to 16 seconds).
See page 278 in “References” for a description of this feature.
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 279 in “References” for further description of this feature.
Select Stand Mode Time Setting
To configure this feature, sc
an the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
a
t left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
$CSNTM
DEFAULT
04 = 2 Seconds
Scanning Active Time = 3 seconds
Scanning Active Time = 5 seconds
Scanning Active Time = 8 seconds
$CSNET03(CR)
$CSNET05(CR)
DEFAULT
$CSNET08(CR)

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux