Datalogic Gryphon Series User Manual

Enter/Exit Programming Mode BT Security Features
246 Gryphon™ I GD44XX / GBT4400/GM440X
BT PIN Code
After enabling Security Mode (see "BT Security Mode" on page 245), specify whether you want
to set a 4-digit or a 16-digit PIN Code. Se
e page 287 for detailed information and examples for
setting this feature.
Select PIN Code Length
Set PIN Code
Determine the desired characters for the PIN code, then convert to hexadecimal using the
ASCII Chart on the
inside back cover of this manual. See page 287 for detailed information and
examples for setting this feature.
Select 4-character BT PIN Code
Select 16-character BT PIN Code
$CBTPC\r
DEFAULT
$CBTP6\r
Set 4-character BT PIN Code
To configure this feature, s
can the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
a
t left followed by the digits from the Alphanumeric
characters in
Appendix D. Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
ba
r code again.
Set 16-character BT PIN Code
CANCEL
Make a mistake? Scan the CANCEL bar code to
abor
t and not save the entry string. You can then
start again at the beginning.
$CBTPS00\r
~$CBTPS01\r
~
DEFAULT
31323334 = Default PIN Code is 1234

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux