Datalogic Gryphon Series User Manual

Maxicode Enter/Exit Programming Mode
Product Reference Guide 215
Maxicode Set Length 2
This feature specifies one of the bar code lengths for Maxicode Length Control. Length 2 is the
maximum label length if in Variable Length Mode, or th
e second fixed length if in Fixed Length
Mode. Characters can be set from 0001 to 0145 characters in increments of 0001 (pad with
zeroes).
See page 265 for detailed instructions on setting this feature.
Select Maxicode Length 2 Setting
To configure this feature, sc
an the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
a
t left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start again at
the beginning.
CANCEL
$CMXL2
~
DEFAULT
Length 2 is 0145 Characters

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux