Micro QR Code Enter/Exit Programming Mode
Product Reference Guide
227
Micro QR Code
Set Length 2
This feature specifies one of the bar code lengths for Micro QR Code Length Control. Length 2
is the maximum label length if in Variable Length Mode, or the second fixed length if in Fixed
Length Mode. Characters can be set from 0001 to 0035 characters in increments of 0001 (pad
with zeroes).
See page 265 for detailed instructions on setting this feature.
Select QR Code Length 2 Setting
To configure this feature, sc
an the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
a
t left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start again at
the beginning.
CANCEL
DEFAULT
Length 2 is 0035 Characters
To Next Page
Loading...
