Datalogic Gryphon Series User Manual

Configuring the Base Station Setup
Product Reference Guide 25
Figure 11. Disconnecting the Cable
Connecting the Base when Security Pin is Enabled
When connecting the Base to a system that has a custom Security Pin enabled, follow the steps
below in the order shown:
1. Power down the host system.
2. Connect the appropriate interface
cable into the Base as shown in Figure 10 .
3. Place the reader in the Base.
4. Power up the host. The reader will link to the Base
5. When the host completely powers up, a new custom Security Pin Code may be sent to the
r
eader and Base, depending on host configuration. Contact Datalogic Technical Support
for more information.
Insert
Paper Clip
If you want to change security settings or set up a PIN, see "BT Security
Mode" starting on page 245
.

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux