Datalogic Gryphon Series User Manual

Enter/Exit Programming Mode
38 Gryphon™ I GD44XX / GBT4400/GM440X
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each pro-
gramming page, when applicable.
2. Scan the bar code to set the desired programming feature. You may need to cover unused
bar codes on the page, and possibly the facing pag
e, to ensure that the reader reads only
the bar code you intend to scan.
3. If additional input parameters are needed, go to Appendix D, Keypad, and scan the
appropriate characters from the keypad.
4. Complete the programming sequence b
y scanning the ENTER/EXIT PROGRAM-
MING bar code to exit Programming Mode.
For more detailed descriptions, programming information and examples
for setting selected
configuration items, see References, starting on page 253.
Additional information about many features can be found in the “Refer-
ences” chapter.
If you make a mistake before the last character, scan the CANCEL bar code
to
abort and not save the entry string. You can then start again at the
beginning.
By default, the handheld will decode bar code labels only when they are
cl
ose to the center of the aiming pattern. This allows the handheld to accu-
rately target labels when they are placed close together
, such as on a pick
sheet. See
Pick Mode, starting on page 100.

Datalogic Gryphon Series Specifications

General

Connectivity	USB, RS-232, Keyboard Wedge, Bluetooth
Scan Pattern	Single-line or omnidirectional
Humidity	5% to 95% non-condensing
Decode Capability	1D and 2D barcodes
Ambient Light	Up to 100, 000 lux