132 Configuring System Information
Figure 6-23. Operational Mode Configuration Confirmation
4.
To confirm the mode change, select
Yes
.
5.
Click
Apply Changes
to change the mode.
Changing the Operating Mode Using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• Operational Mode Commands
Defining IP Addressing
Use the IP Addressing page to assign management interface and default gateway IP addresses, negotiate
with the Domain Name System, set a Default Domain Name, perform Host Name Mapping, and define
ARP and DHCP parameters for the interfaces.
To display th e IP Addressing
page, click System > IP Addressing in the tree view. Use this page to go to
the following features:
•Out of Band Interface
• Domain Name Server (DNS)
• Default Domain Name
•Host Name Mapping
• Dynamic Host Name Mapping
•ARP Table
• IPv6 Management Features
To Next Page
Loading...
