Configuring System Information 219
Removing a User Security Model Table Entry
1.
Open the
User Security Model
page.
2.
Click
Show All
.
The
User Security Model Table
page displays.
3.
Select an entry.
4.
Check the
Remove
check box.
5.
Click
Apply Changes
.
The entry is removed, and the device is updated.
Defining SNMP Users Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide
:
• SNMP Commands.
Communities
Access rights are managed by defining communities on the SNMPv1, 2 Community page. When the
community names are changed, access rights are also changed. SNMP Communities are defined only for
SNMP v1 and SNMP v2.
To display the SNMPv1, 2 Community page, click System > SNMP > Communities in the tree view.
To Next Page
Loading...
