Dell PowerConnect M8024 - Snmpv3 User Security Model (USM)

Configuring System Information 215
Figure 6-95. Access Table
Removing a Group
1. Open the Access Control Configuration page.
2. Click Show All .
The
Access Table opens.
3. Select a group.
4. Check Remove .
5. Click Apply Changes .
The group is removed, and the device is updated.
Defining SNMP Access Control Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• SNMP Commands.
SNMPv3 User Security Model (USM)
Use the SNMPv3 User Security Model (USM) page to assign system users to SNMP groups and to
define the user authentication method.
To display the SNMPv3 User Security Model (USM) page, click System > SNMP > User Security
Model in the tree view
.